netconfig ifconfig

Dear Sir,

I am trying to load the max capacity of my Trixbox with OpenVox card, 3 FXO and 9 FXS. my NIC connect to D-Link Switch, with no router.

I can not edit Static IP of my Trixbox. I already try this way :
- #netconfig
- #vi /etc/sysconfig/network-scripts/ifcfg-eth0
GATEWAY=192.168.0.1
BOOTPROTO=static
DEVICE=eth0
NETMASK=255.255.252.0
BROADCAST=110.110.1.255
IPADDR=110.110.1.11
ONBOOT=yes

I still can not get the static IP address to maintain trixbox. When start up just appear like this :
For access to the trixbox web GUI use this URL
http://

Please let me know how to configure the Static IP.

Thanks
Sam

I used
- Trixbox-OpenVox 2.2.4
-Motherboard MSI 945P Neo-5, chipset Intel 945
- Intel Core 2 Duo E6550

hello,
have you tried to set the ip from GUI? or run setup to configure that.
regards!
James.zhu

Dear Sir,
I did not. I think I need the Network Driver Realtek RTL8100C for Linux. Until now have not found.

Thanks alot.
Sam

Dear Sir,

I switch the Motherboard to Asus P5PE-VM, I can set the Static IP now.

So - Trixbox-OpenVox 2.2.4 is not suitable for Motherboard MSI 945P Neo-5 chipset Intel 945 because Trixbox-OpenVox 2.2.4 does not have LAN Driver Realtek RTL8100C for MSI 945P Neo-5 Motherboard.

So, could You give me the list of some motherboards that suitable for Trixbox-OpenVox 2.2.4 ? I believe you have tested some Motherboards for Trixbox-OpenVox 2.2.4. This information is very important for me to run my business with OpenVox.

Regards,
sam

hello,
i am not very sure which version can support your Network cards, that version is based on the trixbox, you can go to trixbox website to check with other versions, or go to this website:
www.asteriskmotherboards.com/ .
regards!
james.zhu