keywords: ip pbx voip gateway gsm gateway

× Questions about B100/200/400/800 ISDN BRI Cards

missing callerid in mISDN & bristuff - B100P

10 years 2 months ago #5595 by pablo

958304495 is the called phone number (not incoming number).

Sorry, i dont know howto use ztmonitor to extract the callerid on an zap channel, until now i think it was a tool for redord audio :(. Can you help me with that please ?

10 years 2 months ago #5599 by james.zhu
10 years 2 months ago #5600 by pablo

ok, i've used ztmonitor with the follow sintax:

ztmonitor 1 -vv -f file:
(1 is the channel in use) but i can't see callerid num for anywhere while it's running but a TX/RX row that increments and reduces meanwhile the duration of conversation.

ztmonitor 1 -vv -f file
Output to file
Run e.g., 'sox -r 8000 -s -w -c 1 file file.wav' to convert.

Visual Audio Levels.
Use zapata.conf file to adjust the gains if needed.

( # = Audio Level * = Max Audio Hit )
(RX <
####* Rx: 844 ( 844) Tx: 0 ( 0)

I dont know if it's OK. The generated file is a raw one and i suppose that must be converted or similar for extract information, isnt ?
10 years 2 months ago #5604 by Joe.Yung
Please using the following simple syntax to record audio files.
ztmonitor 1 -v -r streamrx.raw -t streamtx.raw

where 1 means the running channel, and there are two audio files streamrx.raw and streamtx.raw after you executing this command. Please post them here or send to my email box.

10 years 2 months ago #5606 by pablo

ok, i've attach the two files grouped in the tar file streams.tar.

10 years 2 months ago #5607 by Joe.Yung
I have analyzed your attachment's content,and it included two files there. But I didn't find any callerid information with tool Adobe Audition. Here is the screenshot! Only a ring tone there! Is it possible switch it to mISDN driver?

Time to create page: 0.024 seconds
Powered by Kunena Forum