keywords:pbx ip pbx voip gateway gsm gateway

× Questions about B100/200/400/800 ISDN BRI Cards

B200, elastix and misdn

11 years 6 months ago #758 by usuarioforum
Hi:

I have running elastix 0.9. With a b400 card it works right but with b200 misdn module don't start. When I do a mISDN scan system detect card like bn4s0, not bn2so.

What's de problem?
11 years 6 months ago #759 by james.zhu
hello, Sir:
Please check it from here:
www.openvox.com.cn/bbs/viewtopic.php?t=206
Regards,
James.zhu

11 years 6 months ago #760 by usuarioforum
James:

I have changed the line and now I can detect the card, but still not working. 0 devices found. I can see card in lspci.

My distro is elastix.

Cheers
11 years 6 months ago #761 by james.zhu
hello, Sir:
please post the result of lspci -vvvvvv? or contact me.
my msn:zhulizhongum@hotmail.com
Regards,
James.zhu

11 years 6 months ago #789 by usuarioforum
Hi james:

Here is the info:

0a:01.0 ISDN controller: Cologne Chip Designs GmbH ISDN network Controller [HFC-4S] (rev 01)
Subsystem: Cologne Chip Designs GmbH Unknown device e888
Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 217
Region 0: I/O ports at 4400
Region 1: Memory at efa01000 (32-bit, non-prefetchable) [disabled] [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+


More things... In line 277 there isn't info about pci id. I have changed this line:

elif ${LSPCI} -n -v -s "${line:5}" | ${GREP} "Subsystem" | ${GREP} "1397:b566\|1397:b569" > /dev/null ; then
addcard "BN2S0" "" 2 'mode="te" link="ptmp"'
With this info:

#lspci -vv -n
0a:01.0 0204: 1397:08b4 (rev 01)
Subsystem: 1397:e888

Wiith this option mISDN scan detect the card, but when the systems start says 0 devices found. If I don't modify the file, scan detect the card like 4 ports card, but the system detect one device when start.
11 years 6 months ago #790 by james.zhu
hello, sir:
please email me the ssh account. i will check it for you.
Regards,
James.zhu

Time to create page: 0.022 seconds
Powered by Kunena Forum