keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
  1. Forum
  3. Telephony Cards Support
  5. B100/200/400/800 Series
  7. error in zaptel after adding chan_misdn.so to modules.conf
× Questions about B100/200/400/800 ISDN BRI Cards

error in zaptel after adding chan_misdn.so to modules.conf

14 years 11 months ago #3066 by trixboxer
I followed guide 'Integration B100P B200P B400P B800P with mISDN.pdf'

All runs ok, I get all circuits busy - I check troubleshooting, and see chan_misdn.conf isn't in /etc/asterisk/modules.conf

I add it near the top

Now I get an error in log file that asterisk won't start because of error in zaptel configuration :-/

I'd like to know what misstep I may have taken so I can make this document easily reproducible as I have to setup 4 more B400P cards on similar hardware.

I've checked all the steps, and it seems fine, I get a steady red light when I connect my isdn to the first port.
[trixbox1.localdomain ~]# misdnportinfo 

Port  1: TE-mode BRI S/T interface line (for phone lines)
 -> Protocol: DSS1 (Euro ISDN)
 -> childcnt: 2
--------
Port  2: TE-mode BRI S/T interface line (for phone lines)
 -> Protocol: DSS1 (Euro ISDN)
 -> childcnt: 2
--------
Port  3: TE-mode BRI S/T interface line (for phone lines)
 -> Protocol: DSS1 (Euro ISDN)
 -> childcnt: 2
--------
Port  4: TE-mode BRI S/T interface line (for phone lines)
 -> Protocol: DSS1 (Euro ISDN)
 -> childcnt: 2
--------


Thanks!!
14 years 11 months ago #3067 by james.zhu
hello,
please check with this: misdn show stacks， make sure your lay1 is up.
james.zhu
14 years 11 months ago #3068 by trixboxer
James,

No such command misdn show stacks

I've added chan_misdn.so to modules.conf - should I go anywhere in particular? I added it to the top, but then the first restart, asterisk didn't load, said zaptel configuration error. Second reboot it loaded (unless I didn't wait enough?)
14 years 11 months ago #3069 by trixboxer
> - Executing [s-CHANUNAVAIL@macro-dialout-trunk:3] NoOp("SIP/123-088995d0", "TRUNK Dial failed due to CHANUNAVAIL (hangupcause: 66) - failing through to other trunks") in new stack

I ran misdn-init start manually to be sure, however, I have it above the amportal line in the rc.local

i] Last edited by trixboxer at 2009-4-21 19:01 [/i
14 years 11 months ago #3070 by Denins.Den
Please send your SSH to This email address is being protected from spambots. You need JavaScript enabled to view it.
14 years 11 months ago #3071 by trixboxer
I've sent the settings - let me know if you have a problem connecting
  1. Forum
  3. Telephony Cards Support
  5. B100/200/400/800 Series
  7. error in zaptel after adding chan_misdn.so to modules.conf
Time to create page: 0.040 seconds
Powered by Kunena Forum