keywords: ip pbx voip gateway gsm gateway

× Questions about D110/210/410 T1/E1/J1 PRI Cards

Changing Interrupt Frequency in E1/T1 card

9 years 11 months ago #8166 by saigop
Hi,

I saw the feature list of PRI card that there is option to change the interrupt frequency, where can i change that?

Regards,
Gopal.
9 years 11 months ago #8168 by chunlei.yi
hi,
You are able to adjust time to initiate IRQ by the following way.
modprobe wct4xxp ms_per_irq=2 (wct4xxp is the card driver you want to load)
ms_per_irq=2 means every 2 millisecond initiate once IRQ.The valid values of ms_per_irq are one of 1,2,4,8,16, and the default value is 1.
9 years 11 months ago #8169 by saigop
Is it possible to change interrupt pin and interrupt number for BRI card also?
Regards.
9 years 10 months ago #8178 by saigop
Hi,
I have one more doubt lets say I am changing the Interrupt number and Interrupt pin, in lspci it is showing the changes, after I do dahdi restart, only the Interrupt pin changed to the value what i changed but the interrupt number it is showing some dynamic number. Is that normal? please advice.


Regards,
Gopal.
9 years 10 months ago #8179 by tim.june
Yes, it is normal. The interrupt is dynamic, if not, it will not work fine.
BTW, the BRI card is not supportable for changing interrupt pin and frequency.

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Skype: tim.jjune
Time to create page: 0.033 seconds
Powered by Kunena Forum