Starting server give errors interrupt erros

Dear,

When we start our server we got following errors

Anyone any idea?
Kind regards

[novavox11 modprobe.d]# dmesg | grep -i opv
opvxd115 0000:0e:00.0: Found opvxd115 at base address fbff0000, remapped to f895 0000
opvxd115 0000:0e:00.0: 5th gen card with initial latency of 2 and 1 ms per IRQ
opvxd115 0000:0e:00.0: DMA memory base of size 260096 at f7680000. Read: f769fc 00 and Write f7680000
opvxd115 0000:0e:00.0: Firmware Version: c01a8000
opvxd115 0000:0e:00.0: Burst Mode: On
opvxd115 0000:0e:00.0: Octasic Optimizations: Enabled
opvxd115 0000:0e:00.0: FALC Framer Version: 3.1
opvxd115 0000:0e:00.0: Board ID: 00
opvxd115 0000:0e:00.0: Reg 0: 0x3769fc00
opvxd115 0000:0e:00.0: Reg 1: 0x37680000
opvxd115 0000:0e:00.0: Reg 2: 0x352115d1
opvxd115 0000:0e:00.0: Reg 3: 0x00000000
opvxd115 0000:0e:00.0: Reg 4: 0x00000000
opvxd115 0000:0e:00.0: Reg 5: 0x00010001
opvxd115 0000:0e:00.0: Reg 6: 0xc01a8000
opvxd115 0000:0e:00.0: Reg 7: 0x00001f00
opvxd115 0000:0e:00.0: Reg 8: 0x00000000
opvxd115 0000:0e:00.0: Reg 9: 0x00000000
opvxd115 0000:0e:00.0: Reg 10: 0x00000000
opvxd115 0000:0e:00.0: Found an OpenVox Card: OpenVox D130P/D130E
opvxd115 0000:0e:00.0: opvxd115: Launching card: 0
opvxd115 0000:0e:00.0: opvxd115: Span 1 configured for CCS/HDB3/CRC4
opvxd115 0000:0e:00.0: SPAN 1: Primary Sync Source
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00010102, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0101017f
opvxd115 0000:0e:00.0: RCLK source set to span 1
opvxd115 0000:0e:00.0: Recovered timing mode, RCLK set to span 1
opvxd115 0000:0e:00.0: VPM450: Not Present
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00020202, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0201027f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00030302, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0301037f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00040402, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0401047f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00050502, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0501057f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00060602, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0601067f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00070702, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0701077f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00080802, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0801087f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00090902, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0901097f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 000a0a02, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0a010a7f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 000b0b02, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0b010b7f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 000c0c02, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0c010c7f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 000d0d02, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0d010d7f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 000e0e02, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0e010e7f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 000f0f02, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 0f010f7f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00101002, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 1001107f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00111102, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 1101117f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00121202, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 1201127f
opvxd115 0000:0e:00.0: 2G: Got interrupt, status = 00131302, CIS = 0080
opvxd115 0000:0e:00.0: Reg 5 is 1301137f
opvxd115 0000:0e:00.0: Setting yellow alarm span 1
opvxd115 0000:0e:00.0: All spans in alarm : No validspan to source RCLK from
opvxd115 0000:0e:00.0: RCLK source set to span 1

[novavox11 modprobe.d]# lspci
00:00.0 Host bridge: Intel Corporation Xeon E3-1200 Processor Family DRAM Controller (rev 09)
00:01.0 PCI bridge: Intel Corporation Xeon E3-1200/2nd Generation Core Processor Family PCI Express Root Port (rev 09)
00:06.0 PCI bridge: Intel Corporation Xeon E3-1200/2nd Generation Core Processor Family PCI Express Root Port (rev 09)
00:1a.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #2 (rev 05)
00:1c.0 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 1 (rev b5)
00:1c.4 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 5 (rev b5)
00:1c.5 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 6 (rev b5)
00:1c.6 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 7 (rev b5)
00:1c.7 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 8 (rev b5)
00:1d.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #1 (rev 05)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev a5)
00:1f.0 ISA bridge: Intel Corporation C204 Chipset Family LPC Controller (rev 05)
00:1f.2 SATA controller: Intel Corporation 6 Series/C200 Series Chipset Family SATA AHCI Controller (rev 05)
01:00.0 System peripheral: Hewlett-Packard Company Integrated Lights-Out Standard Slave Instrumentation & System Support (rev 05)
01:00.1 VGA compatible controller: Matrox Electronics Systems Ltd. MGA G200EH
01:00.2 System peripheral: Hewlett-Packard Company Integrated Lights-Out Standard Management Processor Support and Messaging (rev 05)
01:00.4 USB controller: Hewlett-Packard Company Integrated Lights-Out Standard Virtual USB Controller (rev 02)
02:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
03:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
0d:00.0 PCI bridge: PLX Technology, Inc. PEX8112 x1 Lane PCI Express-to-PCI Bridge (rev aa)
0e:00.0 Network controller: OpenVox Communication Co. Ltd. D130P/D130E Single-port E1/T1 card (3rd GEN) (rev 15)


[novavox11 modprobe.d]# asterisk -r
Asterisk 1.6.0.26-FONCORE-r78, Copyright (C) 1999 - 2010 Digium, Inc. and others.
Created by Mark Spencer <This email address is being protected from spambots. You need JavaScript enabled to view it.>
Asterisk comes with ABSOLUTELY NO WARRANTY; type 'core show warranty' for details.
This is free software, with components licensed under the GNU General Public
License version 2 and other licenses; you are welcome to redistribute it under
certain conditions. Type 'core show license' for details.
=========================================================================
Connected to Asterisk 1.6.0.26-FONCORE-r78 currently running on novavox11 (pid = 3446)
Verbosity is at least 3
novavox11*CLI> dahdi show status
Description Alarms IRQ bpviol CRC4 Fra Codi Options LBO
D115/D130 (E1|T1) Card 0 Span 1 RED 0 0 0 CCS HDB3 CRC4 0 db (CSU)/0-133 feet (DSX-1)
novavox11*CLI>

Hi.
Where is your error informaiton ?
Please tell me the detail about your problem.

Well, I'm very now to all of this
I'm trying to help a colleague...
When we do the "dadhi show status", we see the message red, so I suppose that their is something wrong?

We also see the interrupt messages in dmesg...

Kind regards

Hi.
Please contact me via skype along.zou and prepare remote access, I will help you to figure it out.

We probably found the error.
We have some exotic kind of ISDN line

Kind regards

Hi.
So, change another ISDN line, did the issue solve ?