Port 1 of A800P cannot be detected

Hi, I have installed the A800P according to the instructions.
But when execute the dahdi_scan , it shows that the first port is non like following:
[2]
active=yes
alarms=UNCONFIGURED
description=OpenVox A1200P/A800P Board 13
name=OPVXA1200/12
manufacturer=OpenVox
devicetype=OpenVox A1200P/A800P
location=PCI Bus 01 Slot 15
basechan=1
totchans=8
irq=22
type=analog
port=1,none
port=2,FXS
port=3,FXS
port=4,FXS
port=5,FXS
port=6,FXO
port=7,FXO
port=8,FXO

It is so strange that the FXS should be 1-4 but changed to 2-5.
Can you tell me if there are some problems with my A800P card?

Hi xnode:
1) please double check if you have plugged corectly the module on first slot.
2) if you make sure it was plugged corectly, you can change the first module with the second one.
3) move to other PCI slot.
please have a try ,and let me know the result.

i] Last edited by xin.liu at 2010-4-12 11:18 [/i

Hello，
Can you see the channels after you execute the command "dahdi_cfg -vvvv"? And what is the status of this port's LED?

Hello.
I executed the command dahdi_cfg -vvvv, the port 1 don't work.
I exchanged the the first fxs module and the second one just now, and it work fine now.
It seems that the first module is not installed properly.
But i also think this problem is strange,there should some bugs in the driver when some port cann't be found.

hello,
Please post your errors or bugs here. If possible, send your SSH to us.Let us install for you!

Hi xnode:
Maybe it is caused by poor contact of hardware, drivers will not have this problems.