Help .fxs error PROSLIC ON MODULE 3 FAILED ON POWERUP

Hello
We have bought a badge openvox a400p with an I modulate fxs and an I modulate fxo.
We have installed it in a pc asus P5GC-MX/1333 with 1gb by heart ram and a serial disk ties of 160 gb. The software that we use is elastix 1.1 stable version.
The problem is that when I make the detection of the hardware, it is not recognized the card fxs and elastix it reports the following error:
PROSLIC ON 3 FAILED MODULATES ON POWERUP WITHIN 501 MS (6000 mV) only)

Hecambiado the feeder but anything doesn't happen. I have Also disabled of the bios certain elements that don't serve me but I cannot solve the problem.
You could to help me.
greetings and thank you to read my message.
Fabian Franetovich
This email address is being protected from spambots. You need JavaScript enabled to view it.

hello, drsoft:
you can modprobe -r wctdm and modprobe wctdm again. if still can not work, please email me you ssh account. my email is:[email protected].
regards!
James.zhu

Hi James.zhu

Thank you for your answer. I have observed that when one makes Hardware Detection, elastix generates the file zaptel.conf in this way:

# Autogenerated by /usr/sbin/genzaptelconf -- do not hand edit

# Zaptel Configuration File

#

# This file is parsed by the Zaptel Configurator, ztcfg

#



# It must be in the module loading order





# Span 1: WCTDM/0 "Wildcard TDM400P REV E/F Board 1" (MASTER)

fxsks=1

fxoks=4



# Global data

# I change loadzone and defaultzone because i live in Italy

loadzone = it

defaultzone = it



I don't understand because it is generated fxsks=1 and fxoks=4 when in my openvox 400 my modules are exactly invested fxo in the slot 1 and my fxs this in the I modulate 4.

Is this correct that it is this way?

With this configuration fxs is active but when i make :

[root@elastix ~]# modprobe -r wctdm

FATAL: Module wctdm is in use.

[root@elastix ~]# modprobe wctdm

[root@elastix ~]#

Is this correct?

Fabian

hi:
yes, it is true, if it is FXO, it will show FXSKS in zaptel and zata.conf. however, i it is FXS, it will show FXO in zaptel. you can try to generate the zaptel and zapata.conf using ./genzaptel -sdvM, it is good tool for setting.
regards!
James.zhu