- Thank you received: 0
×
Questions about A400/800/1200 Analog Interface Card
New A400P problems
15 years 4 months ago #2359
by chuck5761
Hello,
I've just installed a new A400P in my server with 2 FXS and 2 FXO cards, and installed pbx in a flash 1.3 from scratch.
I forgot all about the power connector, and powered up the computer once with the A400P with the power connector not installed. There were no phones or lines attached during this error, and I powered the computer back off and installed the power cable within 5 minutes after I realized the problem.
After installing PIAF, when I run ztcfg, I get "0 channels to configure". I haven't been able to get the FXO/FXS cards to be recognized. What should I do?
I've just installed a new A400P in my server with 2 FXS and 2 FXO cards, and installed pbx in a flash 1.3 from scratch.
I forgot all about the power connector, and powered up the computer once with the A400P with the power connector not installed. There were no phones or lines attached during this error, and I powered the computer back off and installed the power cable within 5 minutes after I realized the problem.
After installing PIAF, when I run ztcfg, I get "0 channels to configure". I haven't been able to get the FXO/FXS cards to be recognized. What should I do?
- Denins.Den
-
- Offline
- Administrator
-
Less
More
- Posts: 4
- Thank you received: 1
15 years 4 months ago #2360
by Denins.Den
Please send your SSH to me, i will check it
This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.
- jlaratomas
-
- Offline
- New Member
-
Less
More
- Thank you received: 0
Time to create page: 0.040 seconds