keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
  1. Forum
  3. Telephony Cards Support
  5. A400/800/1200 Series
  7. A400 in Xenserver
× Questions about A400/800/1200 Analog Interface Card

A400 in Xenserver

14 years 9 months ago #3667 by jsalinasf
Hi all.
Does anybody works with Xenserver and A400 ?

In My Xenserver:
0a:00.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Unknown device b100:0003
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (250ns min, 32000ns max)
Interrupt: pin A routed to IRQ 7
Region 0: I/O ports at 4000
Region 1: Memory at efa00000 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=55mA PME(D0+,D1-,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+


In my Elastix didn't exist. Does anynone knows something about this ?
Thank you in advance.
Jose.
14 years 9 months ago #3668 by Robert
hello!
what did not exist in your elastix? could you please give me detail information about the problem
14 years 9 months ago #3672 by james.zhu
hello:
i suggest not using use Xenserver. the pci id is not correct, you have to patch that, please show your full lspci message.
can you please email your ssh to fix that?
james.zhu
14 years 9 months ago #3679 by jsalinasf
Of course Mr. Zhu.
You have it in your email
Thank you very much...
  1. Forum
  3. Telephony Cards Support
  5. A400/800/1200 Series
  7. A400 in Xenserver
Time to create page: 0.034 seconds
Powered by Kunena Forum