×
Notice
The forum is in read only mode.
Forum
Telephony Cards Support
A400/800/1200 Series
Reversing polarity
×
Questions about A400/800/1200 Analog Interface Card
Reversing polarity
14 years 6 months ago #3940
by stojko
My log is full of this kind of event:
[2009-10-08 08:15:51] DEBUG[12050] chan_zap.c: Ignoring Polarity switch to IDLE on channel 6, state 6
[2009-10-08 08:15:51] DEBUG[12050] chan_zap.c: Polarity Reversal event occured - DEBUG 2: channel 6, state 6, pol= 0, aonp= 0, honp= 0, pdelay= 600, tv= 852100917
What does it mean?
Robert
Visitor
14 years 6 months ago #3944
by Robert
hello:
It is just a debug, i do not think that it would cause any problems.
Does your pstn line have reverse polarity application? If it does, please try to set:
answeronpolarityswitch=yes
hanguponpolarityswitch=yes
in zapata.conf.
14 years 6 months ago #3972
by stojko
Hello, yes that solved my problem. Also, the problem with no carrier detected signal resolved with this. Thank you very much.
Forum
Telephony Cards Support
A400/800/1200 Series
Reversing polarity
Time to create page: 0.031 seconds