Hi, i try setup A400E card according to Openvox manual.
scan_dahdi show card ok
dahdi_cfg -vvvv look also ok
but when i try "dahdi show channels" asterisk repond like "-bash: dahdi: command no found"
Hi,
Was it also show "-bash: dahdi: command no found" when you typed "dahdi show channels" after "module load chan_dahdi.so"? Plwase send the log file (/var/loag/asterisk/full) to me. My Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Hi, yes show same error after that.
I also repeat the instruction from manual step by step. there are not errors until last command (dahdi show channels)
here some files
.# Autogenerated by /usr/sbin/dahdi_genconf on Wed Apr 13 09:48:21 2011
# If you edit this file and execute /usr/sbin/dahdi_genconf again,
# your manual changes will be LOST.
# Dahdi Configuration File
#
# This file is parsed by the Dahdi Configurator, dahdi_cfg
#
# Span 1: WCTDM/4 "Wildcard TDM400P REV E/F Board 5" (MASTER)
fxsks=1
echocanceller=mg2,1
# channel 2, WCTDM/4/1, no module.
# channel 3, WCTDM/4/2, no module.
# channel 4, WCTDM/4/3, no module.