I can make intern-calls now its nice. But I want to take it thenext-level... I want to make extern-calls. How I must configure thetrunks?
I've rode Elastix Without Tears but it don't get it. Its confusingbecause I dont use a VOIP-Provider. I want to connect via ISDN.
I dont have a VOIP-provider
I want to connect to the outside-world via ISDN
I use KPN Telecom its a Dutch Internet provider
Thanks alot folks!
Port 1: TE-mode BRI S/T interface line (for phone lines)
-> Protocol: DSS1 (Euro ISDN)
-> childcnt: 2
My Elastix machine recongnize the ISDN Card but I dont know how to configure the outbound call and the inbound call. I rode Without Tears but they only use PSTN for example not ISDN.
The 4 red leds are blinken so the driver is loaded correctly
hi:
the system is running with a B400P. the elastix Without Tears does not show the conf for B400P, you check with this:
http://www.openvox.cn/bbs/viewthread.php?tid=752
please make sure change to 4 ports instead of 8 ports in that thread. yes, it is a BN4SO card. if you run dmesg, you will see more info about openvox B400P.
regards!
James.zhu
"We have to edit the "/etc/asterisk/misdn.conf" file to activate all 8 ports. Open the "/etc/asterisk/misdn.conf" file and
from the end of file remove/comment the below mentioned lines"
So do i must delete the comments or leave it and add:
16. And add the below lines at the end of "/etc/asterisk/misdn.conf" [isdn_openvox] ; define your ports, e.g. 1,2 (depends on mISDN-driver loading order) ports=1,2,3,4,5,6,7,8 ; context where to go to when incoming Call on one of the above ports msns=* context=from-pstn